The bronzing machine of a single sheet of paper with a small size plane can be hot stamped one by one with a semi-automatic hot stamping machine, but the speed is very slow, and it is not too safe, and the automatic hot stamping machine came into being in this case. It is made by adding feeding device and unloading device on the basis of semi-automatic bronzing machine. Paper can be stacked on the paper feeding table, the workbench can be automatically raised according to the height of the paper pile, convenient for the paper takeer to transfer the paper to the gilding table, for paper and thin products, it is not allowed to move in the hot stamping process, nor is it allowed to stain the gilded paper, the paper takeer can also press the paper at the same time to prevent him from being stained by the gilded paper. Therefore, the design of the gilding pattern should take into account the bite edge of the edge of the paper, at least 15-20mm distance, if this distance is too small, it is necessary to consider installing an aspirator on the workbench, otherwise, the automatic scalding process is difficult to carry out continuously. The gilded paper is adsorbed or clipped by the unloading manipulator and transferred to the unloading table, and the height of the unloading table can also be automatically reduced according to the height of the paper stacking. The hot stamping head of the fully automatic flat hot stamping machine adopts servo motor control, which is easy to adjust, high precision and uniform pressure. The guide control of the manipulator adopts a precision linear guide, the error is small, and the positioning accuracy of the paper can be within 0.3-0.5mm.
